通过Word的菜单命令将保存的图片文件保存到Word文档
插入-图片-来自文件。
使用此命令，您可以在屏幕上保存程序页面
（逆时针旋转90度）到图片中的磁盘文件
（增强图元文件）格式。此文件的文件扩展名必须为
成为EMF。
图片文件由MS Office产品等使用。例如，您可以插入
通过Word的菜单命令将保存的图片文件保存到Word文档
插入-图片-来自文件。
标准用户界面：使用此命令可以打印
屏幕上的程序。
用户界面：使用此命令可以打印程序
页。您可以打印所有页面或所需页面（或页
范围）。
一页（即左边的页选项卡）的页码为1。
打印时显示当前可见页面的页码
对话框中。
此命令停止执行DriveAP。
如果有一个驱动器连接到您的电脑硬件，您可以
通过此命令与驱动器的软件连接。如果还有更多
多个驱动器连接到电脑硬件，您可以选择
可用驱动器列表中的驱动器。
连接驱动器的标识符显示在
屏幕
此命令将DriveAP的操作模式更改为脱机模式（请参阅3章-使用中的脱机模式一节）
DriveAP）。
如果要使用连接到电脑的另一个驱动器，请断开
通过此命令连接当前已连接的驱动器，并连接到
另一个按命令驱动的驱动器-连接。
此命令将DriveAP的操作模式更改为独立模式。
此命令上载并显示
连接的驱动器。

• 

Picture files are used by e.g. MS Office products. You can e.g. insert the saved Picture file to a Word document by Word’s menu command Insert - Picture - From File. Using this command you can save the program page on the screen (rotated 90 degrees counterclockwise) to a disk file in the Picture (Enhanced Metafile) format. The filename extension of this file must be EMF. Picture files are used by e.g. MS Office products. You can e.g. insert the saved Picture file to a Word document by Word’s menu command Insert - Picture - From File. Standard User Interface: Using this command you can print the program on the screen. Advanced User Interface: Using this command you can print program pages. You can print either all pages or the desired page (or page range). The page number of the first page (i.e. the leftmost page tab) is 1. The page number of the currently visible page is displayed in the Print dialog box when you have selected the Print command. This command stops the execution of DriveAP. If there is a drive connected to your PC hardware, you make a software connection to the drive by this command. If there are more than one drive connected to the PC hardware, you can select the drive from the list of available drives. The identifier of the connected drive is displayed at the top of the screen. This command changes the operating mode of DriveAP to the OffLine Mode (see Section Off-Line Mode in Chapter 3 - Use of DriveAP). If you want to use another drive connected to your PC, disconnect the currently connected drive by this command and make a connection to another drive by command Drive - Connect. This command changes the operating mode of DriveAP to the StandAlone Mode. This command uploads and displays the AP program of the connected drive.