MDD093C-N-020-N​2M-110GA1
电机配有电机反馈，用于评估位置和速度以及检测转子位置。电机有图2.20所示的版本。
版本电机反馈始终由转速表反馈组成，并可额外安装编码器。
图2.20：可用的电机反馈版本
2.4.1. 转速表
这种设计可以检测和评估转子位置和
速度速度反馈值是在
一些型号和适用于：
•标准应用（转速计类型“C”；见类型代码）
•具有极高平滑运行质量的应用
（转速计类型“F”；参见类型代码）
“Tachofeedback”版本可用于所有机器，
例如，通过线性标尺或均匀旋转的应用程序进行直接位置评估。
可选择转速计电压以满足以下要求：
•匹配标称电机速度
标称速度>3000 min-1转速计电压等于1.5V/1000
小值-1。
标称电机转速为3000英镑min-1转速计电压等于3V/
1000分钟-1。
•1.5 V/1000 min-1，适用于大标称转速为3000 min-1的电机中转速超过3200 min-1的情况
•6 V/1000 min-1，适用于电阻要求较高的应用
干扰测速反馈线或要求在以下位置平稳运行
大标称速度为1600 min-1。
表2.21列出了每条电机线路的选项。
转速表
第二轴端转速表
（用于安装客户的编码器）
装有编码器的转速表
（增量或编码器）

The motors are equipped with a motor feedback for the evaluation of position and speed and for the detection of rotor position. The motors are available in those versions illustrated in Figure 2.20. Versions The motor feedback is always made up of a tachofeedback and can be additionally fitted with an encoder. Fig 2.20: Available motor feedback versions 2.4.1. Tachofeedback This design makes it possible to detect and evaluate both rotor position and velocity. The velocity feedback value is generated with residual ripple in some models and is suited for: • either standard applications (tacho type „C“; see type code) • applications with extreme high smooth run qualities (tacho type „F“; see type code) The "Tachofeedback" version can be used in all machines in which there is, for example, a direct position evaluation via a linear scale or with applications with uniform rotations. Tacho voltage can be selected to meet the following: • to match nominal motor speed With a nominal speed of > 3000 min-1 tacho voltage equals 1.5V/1000 min-1. With a nominal motor speed of £ 3000 min-1 tacho voltage equals 3V/ 1000 min-1. • 1.5 V/1000 min-1 for speeds exceeding 3200 min-1 in motors with a maximum nominal speed of 3000 min-1 • 6 V/1000 min-1 for applications making higher demands of the resistance to interference in tachofeedback lines or requiring smooth run qualities at a maximum nominal speed of 1600 min-1. The options for each line of motor have been compiled in Table 2.21. Tachofeedback Tachofeedback with second shaft end (for mounting the encoder of the customer) Tachofeedback with mounted encoder (Incremental or absolute encoder)