MAC112D-O-ED4
2.3. 电气特性端子图图图2.17所示的端子图仅为示意图。它代表了操作MAC AC伺服电机所需的所有电气连接的检查表。图2.17：端子示意图MAC电机上有以下电气连接：•电源连接（始终存在）•转速反馈连接（始终存在）•增量或编码器连接（这取决于所实施的电机类型）角度连接器不能与轴向表面冷却装置结合使用。FABEZSTECK安装螺钉连接器外壳连接器零件带盖螺母J M APMAC伺服电机温度开关U 3收集在动力电缆中，动力电缆收集在转速计反馈电缆阻塞制动驱动控制器NC控制单元增量或编码器电缆PLC或硬件电路2中。技术数据•DOK-电机*-MAC******-PRJ1-EN-P•04.96 23如果电机上安装了用于表面冷却的鼓风机，则电机鼓风机连接也在那里。端子图中未显示这一点。INDRAMAT驱动器的电气连接已标准化，以尽量减少电缆多样性。12节和13节规定了给定应用和电机类型的电气连接。

2.3. Electrical Features Terminal diagram The terminal diagram shown in Figure 2.17 is purely schematic. It represents a checklist for all the necessary electrical conections to operate a MAC AC servo motor. Fig 2.17: Schematic terminal diagram The following electrical connections are on a MAC motor: • Power connection (always present) • Tachofeedback connection (always present) • Incremental or absolute encoder connection (this depends on the type of motor implemented) Angle connectors cannot be used in conjunction with an axial surface cooling unit. FABEZSTECK Mounting screws Connector housing Connector part with cap nut J M APMACSERVO Motor thermo switches U 3 collected in power cable collected in tacho feedback cable blocking brake drive controller NC control unit incremental or absolute encoder cable PLC or hardware circuitry 2. Technical Data • DOK-MOTOR*-MAC********-PRJ1-EN-P • 04.96 23 If a blower for surface cooling is mounted to the motor, then a motor blower connection is also there. This is not shown in the terminal diagram. The electrical connections of INDRAMAT drives have been standardized to minimize cable diversity. Sections 12 and 13 specify the electrical connections for a given application and motor type.