MAC112C-0-ED-2-​C/130-A-0/S005
单独使用抱闸不能保证人员的安全，因为它可能会发生故障或磨损。必须采取额外措施确保人员安全。这些必须由机器制造商进行，例如，可以安装第二个制动器。保持制动器不是工作制动器。在关闭制动器的情况下，电机转动20000转后，它可能会磨损。如果电机存放时间超过两年，则在使用前需要磨合。研磨：1。以大约100速的速度运行电机。2、关闭抱闸并保持其关闭约60秒。注意：打开制动保持器至PLC或硬件电路的导线。3、60秒后关闭驱动器。4、将抱闸重新连接至PLC或硬件电路

The holding brake alone cannot guarantee the safety of personnel as it can fail or wear down. Additional measures must be taken to ensure personnel safety. These must be undertaken by the manufacturer of the machine and can, for example, be the mounting of a second brake. The holding brake is not a working brake. It can wear down after 20,000 motor revolutions against the closed brake.If the motor is stored for a period exceeding two years, then it is necessary to grind it in before using it. To grind it in: 1. Run the motor at a speed of approximately 100 speed. 2. Close the holding brake and keep it closed for approximately 60 seconds. Note: Open the conductor of the holding brake to the PLC or the hardware circuitry. 3. Shut down the drive after 60 seconds. 4. Reconnect the holding brake to the PLC or the hardware circuitry