VDIF0625452205
验证安装是否正确：
 验证整个驱动系统的机械安装：
 安装是否符合规定的距离要求？
 是否按规定的拧紧力矩拧紧了所有紧固螺钉？
 验证电气连接和布线：
 是否连接了所有保护接地导体？
 所有保险丝的额定值是否正确；保险丝是否为规定类型？
 你把电缆的所有电线都连接起来了吗？还是把它们绝缘了？
 您是否正确连接并安装了所有电缆和连接器？
 接头的机械锁是否正确有效？
 你把信号线连接好了吗？
 所需的屏蔽连接是否符合EMC标准？
 您是否采取了所有措施来实现EMC法规遵从性？
 驱动器安装是否符合所有当地、地区和国家电气安全规范
设备的终位置？
 验证所有盖和密封件是否已正确安装，以达到所需的
保护

Verify proper installation:  Verify the mechanical installation of the entire drive system:  Does the installation meet the specified distance requirements?  Did you tighten all fastening screws with the specified tightening torque?  Verify the electrical connections and the cabling:  Did you connect all protective ground conductors?  Do all fuses have the correct rating; are the fuses of the specified type?  Did you connect all wires of the cables or insulate them?  Did you properly connect and install all cables and connectors?  Are the mechanical locks of the connectors correct and effective?  Did you properly connect the signal wires?  Are the required shield connections EMC-compliant?  Did you take all measures for EMC compliance?  Does the drive installation conform to all local, regional, and national electrical safety codes for the eventual placement of the equipment?  Verify that all covers and seals have been properly installed to achieve the required degree of protection.