VDI67B22271200
 将电机相和保护接地导线连接至CN10。确认连接U、V、，
电机和设备的W和PE（接地）匹配。
 注意端子螺钉的规定拧紧力矩。
 将带有标签5的白色导线或黑色导线连接到CN11的接头BR+。
将带有标签6的灰色导线或黑色导线连接到CN11的接头BR-上。
对于LXM32MU45。。。LXM32MD72：
 确认接头正确锁定卡入。
 将电缆屏蔽连接到屏蔽夹（大表面积接触）。
屏蔽线夹电机电缆
对于LXM32MD85和LXM32MC10：
 用屏蔽夹将电缆屏蔽连接到EMC导轨（大表面积接触）。
确认各导线位于各导线导管中。
 如果未连接外部制动电阻器，请安装电缆导管。
屏蔽线夹电机电缆

 Connect the motor phases and protective ground conductor to CN10. Verify that the connections U, V, W and PE (ground) match at the motor and the device.  Note the tightening torque specified for the terminal screws.  Connect the white wire or the black wire with the label 5 to connection BR+ of CN11. Connect the gray wire or the black wire with the label 6 to connection BR- of CN11. For LXM32MU45 ... LXM32MD72:  Verify that the connector locks snap in properly.  Connect the cable shield to the shield clamp (large surface area contact). Shield clamp motor cable For LXM32MD85 and LXM32MC10:  Connect the cable shield with a shield clamp to an EMC rail (large surface area contact). Verify that the individual wires are in the individual guides.  If you do not connect and external braking resistor, mount the cable guide. Shield clamp motor cable