TSXSCPCX2030
•好在现场收到变压器后立即安装变压器，并加注变压器油。
但是，如果不可能，应采取以下预防措施来存放主体
以及更长时间的配件：
•存储区域应足够大，并应便于检查。
i、 应将其存放在坚固平整的表面上。
二。仓库周围未受污染，仓库内未积水
地区
iii.在下方提供足够的空间，以便空气自由流动，并用于起吊、顶升等。
b） 充气存储
•建议在收到变压器油后立即加注变压器油。如果无法加注机油
收到主体后，必须立即用充满正氮气的干燥氮气进行保存
约20°C时的压力为0.2 kg/cm2。（有关压力Vs
温度表）。
•充气储存的持续时间应限制在收到以下主体后的3个月内：
地点
•如果内部气体压力因泄漏而下降，可使用
肥皂水。应将此事报告给制造商，以便立即采取纠正措施。
•如果无法立即纠正泄漏，则必须通过放置
在整个油箱上覆盖一层防水油布，直到可以采取补救措施为止。

• It is preferable to erect the transformer immediately on receipt at site and fill with transformer oil. However, if it is not possible, the following precautions should be taken for storing the main body and accessories for longer duration: • The storage area should be adequate and should be easily accessible for inspection. i. The surface on which it should be stored is strong and levelled. ii. Surrounding area of storage is not polluted and water does not accumulate in the storage area. iii. Sufficient space is provided underneath for free flow of air and for lifting, jacking etc. b) GAS FILLED STORAGE • It is recommended to keep the transformer oil filled immediately after receipt. If oil cannot be filled immediately after receipt of main body, it must be retained with dry nitrogen gas filled at a positive pressure of 0.2 kg/ cm2 at about 20°C. (Please refer Fig.– 2.1 on page 15 for Pressure Vs Temperature Chart). • The duration of gas filled storage should be limited to 3 months from the receipt of main body at site. • If the pressure of gas inside drops due to leakage, the leakage point may be detected by using soap water. The matter shall be reported to the manufacturer for immediate corrective action. • Should it not be possible to rectify the leak immediately, the transformer must be covered by putting a tarpaulin sheet over the whole tank until remedial measures can be carried out.