TSXP57303M
•从主体上拆下抽头开关、CT等任何内部零件时
运输时，应将其装在装满油或干氮气或合适的
采取措施使其不会吸收水分。
•所有易碎零件，如温度指示器、油位计等，应仔细包装至
避免在运输过程中破损。
•气室式储油柜应配备安装在储油柜内部的气室，以及
在略为正的压力下充入空气，使其在油枕内保持完全密封。
这是为了避免储油柜内的空气室在运输过程中发生相对运动，并避免
搬运过程中损坏空气电池。
•专门用于运输的所有盲板、阀门防护装置等均已涂漆
与变压器颜色不同（通常为邮局红色），并应予以保存
供将来使用。
2.2.3吊装
•变压器只能使用主体上提供的起重护柱进行起吊
意图所有起重护柱应同时使用。应注意使用
吊装用吊索尺寸正确，吊装角度不应超过60◦.
•钢丝绳的安全载荷和与提升角度相对应的乘数
如图2.2所示

• When any internal part like tap changer, CT's etc. are removed from the main body for
transportation, they shall be despatched in tanks filled with oil or dry nitrogen gas or suitable
measures are taken so that they do not absorb moisture.
• All fragile parts such as temperature indicators, oil level gauges etc. shall be carefully packed to
avoid breakage in transit.
• Air cell type conservator shall be despatched with air cell mounted inside the conservator and
inflated with air at a slightly positive pressure so that it remains fully tight inside the conservator.
This is to avoid relative movement of air cell inside the conservator during transit and to avoid
damages to air cell during handling.
• All blanking plates, valves guards etc., which are used exclusively for transportation are painted
with a different colour shade than the transformer (normally post office red) and shall be preserved
for future use.
2.2.3 LIFTING
• Transformers should be lifted only by using the lifting bollards provided on the main body for the
purpose. All the lifting bollards should be used simultaneously. Care should be taken to use the
correct size of sling for lifting and the lifting angle should not exceed 60◦.
• Safe loads of wire ropes and the multiplying factor to be used corresponding to the lifting angles
are shown in Fig. 2.2