TSXDSZ08T2
➢ 禁止未经授权进入变压器附近。
➢ 不要关闭泵回路中的任何阀门，以便将备用泵和电机接入回路。
➢ 油水热交换器中的水压不得超过油压。
➢ 除非油是新的且完全符合is：335，否则不要混合不同品牌/基础的变压器油。
➢ 不要继续使用粉红色（湿）硅胶，应立即更换或重新激活。
➢ 变压器到达现场后，不得在充气状态下存放超过三个月。如果
存放时间较长，主体应装满油。
➢ 不要让三级端子在油箱外部不受保护。
➢ 变压器和过滤机器干燥期间，WTI/OTI温度不得超过70°C
温度超过75°C
➢ 不要并联不符合并联条件的变压器。
➢ 变压器的过载不得超过IS：6600中规定的限值。
➢ 不要让任何CT的二次端子开路。
➢ 变压器处于真空状态时，不得使用兆欧表测量绝缘电阻。
➢ 不要站在真空中的任何容器上。

➢ Do not allow unauthorised entry near the transformer. ➢ Do not close any valve in pump circuit for taking stand by pump and motor into circuit. ➢ Do not allow water pressure to exceed the oil pressure in oil to water heat exchangers. ➢ Do not mix transformer oils of different make/ base, unless oil is new and conforms fully to IS: 335. ➢ Do not continue with pink (wet) silica gel, this should immediately be changed or reactivated. ➢ Do not store transformer in gas filled condition for more than three months after reaching site. If storage is required for longer duration, the main body should be filled up with oil. ➢ Do not leave tertiary terminals unprotected outside the tank. ➢ Do not allow WTI / OTI temperature to exceed 70°C during dry out of transformer and filter machine temperature beyond 75°C ➢ Do not parallel transformers, which do not fulfil the conditions for paralleling. ➢ Do not over load the transformers beyond limit specified in IS: 6600. ➢ Do not leave secondary terminals of any CT open. ➢ Do not measure insulation resistance by using megger when the transformer is under vacuum. ➢ Do not stand on any vessel, which is under vacuum.