TSXCBYACC10
您可以配置仪表的报警/能量LED或数字输出
能量脉动。
•仪表配备报警/能量脉冲LED。配置时
对于能量脉冲，LED发出脉冲，然后用于确定
电能表能量测量的准确性。
•仪表从配置的数字输出端口发送脉冲
然后用于确定电表能量的准确性
脉冲计数器测量。
使用显示器配置报警/能量脉冲LED
您可以使用显示器配置仪表的LED报警或电量
脉冲应用程序。
1、导航至Maint>Setup。
2、输入设置密码（默认为“0”），然后按OK。
3、导航至输入/输出>LED。
4、移动光标指向要修改的参数，然后按
编辑
5、按加号或减号按钮，根据需要修改参数，然后
按OK。
6、按向上箭头退出。按Yes保存更改。
设置选项或范围说明
模式关闭、报警、能量关闭将完全关闭LED。
报警设置报警LED
通知。
能量设置用于能量脉冲的LED。
参数激活Del
活动Rec
活动Del+Rec
无功Del
无功Rec
无功Del+Rec
表观Del
视在Rec
表观Del+Rec
选择哪个累计能量
监测和使用能源的渠道
脉冲。当
LED模式设置为报警。
配置为能量脉冲时，脉冲重量（p/k\U h）1至999999，这
设置定义脉冲的数量
每1 kWh发送至LED，1
kVARh或1kVAh累积能量。
当LED
模式设置为报警。

You can configure the meter’s alarm /energy LED or the digital output(s) for energy pulsing. • The meter is equipped with an alarm / energy pulsing LED. When configured for energy pulsing, the LED emits pulses that are then used to determine the accuracy of the meter’s energy measurements. • The meter sends the pulses from the configured digital output(s) port, which are then used to determine the accuracy of the meter’s energy measurements by pulse counter. Configuring the alarm / energy pulsing LED using the display You can use the display to configure your meter’s LED for alarming or energy pulsing applications. 1. Navigate to Maint > Setup. 2. Enter the setup password (default is “0”), then press OK. 3. Navigate to I/O > LED. 4. Move the cursor to point to the parameter you want to modify, then press Edit. 5. Press the plus or minus buttons to modify the parameter as required, then press OK. 6. Press the up arrow to exit. Press Yes to save your changes. Setting Option or range Description Mode Off, Alarm, Energy Off turns off the LED completely. Alarm sets the LED for alarm notification. Energy sets the LED for energy pulsing. Parameter Active Del Active Rec Active Del + Rec Reactive Del Reactive Rec Reactive Del + Rec Apparent Del Apparent Rec Apparent Del + Rec Select which accumulated energy channel to monitor and use for energy pulsing. This setting is ignored when the LED mode is set to Alarm. Pulse Wt. (p/k_h) 1 to 9999999 When configured for energy pulsing, this setting defines how many pulses are sent to the LED for every 1 kWh, 1 kVARh or 1kVAh accumulated energy. This setting is ignored when the LED mode is set to Alarm.