140CHS11000C
为系统中的芯片组（例如CPU）选择各种选项
北桥和南桥的配置）。的设置
芯片组依赖于处理器，在更改
出厂时设置的默认值。下面是芯片组设置屏幕的示例；实际情况
系统上的选项可能有所不同。
注意：此屏幕中的更改可能导致系统故障。如果问题是
更改完成后，请重新启动系统并访问BIOS。从
退出菜单选择“加载故障保护默认值”，然后重新启动系统。如果系统出现故障
阻止访问BIOS屏幕，有关清除的说明，请参阅章
CMOS。
002.53（C）版权所有1985-2002，American Megatrends，股份有限公司。
BIOS设置实用程序
主PCIPnP引导安全芯片组出口
芯片组设置Intel Montara GML
北桥芯片组
配置选项。
←→ 选择屏幕
↑↓ 选择项目
进入转到子屏幕
F1一般帮助
F10保存并退出
ESC出口
警告：在下面的部分中设置错误的值
可能导致系统故障。
¾Intel Montara NorthBridge配置
¾Hance Rapids SouthBridge配置
¾CPCI（提示HB6）桥接器配置
¾Lan（8254EB）端口路由选项

Select the various options for chipsets located in the system (for example, the CPU configuration and configurations for the North and South Bridge). The settings for the chipsets are processor dependent and care must be used when changing settings from the defaults set at the factory. Below is a sample of the Chipset Setup screen; the actual options on your system may vary. NOTE: Changes in this screen can cause the system to malfunction. If problems are noted after changes have been made, reboot the system and access the BIOS. From the Exit menu select ‘Load Failsafe Defaults’ and reboot the system. If the system failure prevents access to the BIOS screens, refer to Chapter One for instructions on clearing the CMOS. 002.53 (C) Copyright 1985-2002, American Megatrends, Inc. BIOS SETUP UTILITY Main Advanced PCIPnP Boot Security Chipset Exit Advanced Chipset Settings Intel Montara GML NorthBridge chipset Configuration options. ←→ Select Screen ↑↓ Select Item Enter Go to Sub Screen F1 General Help F10 Save and Exit ESC Exit WARNING: Setting wrong values in below section may cause system to malfunction. ¾ Intel Montara NorthBridge Configuration ¾ Hance Rapids SouthBridge Configuration ¾ CPCI (HINT HB6) Bridge Configuration ¾ Lan (8254EB) Port Routing Options