VT11608ARA-1S30
<<操作程序见第5.2节>>
此功能将测量波长切换为真空波长或空气波长
波长。
测量可以在空气或真空波长模式下进行。
在波长和频率之间切换
<<操作程序见第5.2节>>
此功能将水平轴显示切换为波长或频率。
可以显示标记值和分析的波长或频率
后果
平均值<<操作程序见第5.11节>>
此函数执行多个测量并显示平均值。
该功能用于以下情况：光源电平波动时；什么时候
测量数kHz或以下的调制信号；波形中断时
难以测量；当需要获得更高的测量值时
体贴

> This function switches the measured wavelength to either a vacuum wavelength or an air wavelength. Measurement can be performed in either air or vacuum wavelength mode. Switching between Wavelength and Frequency > This function switches the horizontal axis display to wavelength or frequency. You can display either the wavelengths or frequencies of marker values and analysis results. Averaging > This function performs multiple measurements and displays the average values. The function is used in cases such as: when the light source’s level is fluctuating; when measuring a modulated signal of several kHz or less; when the waveform is disrupted and difficult to measure; when it is necessary to obtain even higher measurement sensitivity.